Care & Cleaning: Bushwacker fender flares are built to last; any detergent you use to wash your vehicle is sufficient to clean the flare. Do not use any harsh abrasive detergents.

Care & Cleaning: Bushwacker fender fl ares are built to last; any detergent you use to wash your vehicle is suffi cient to clean the fl are. Do not use any harsh abrasive detergents.

Rear Flare Installation Procedures (Driver’s Side): Holding fl are in position on fender, use a grease pencil to mark six hole locations.

A)Bushwacker only approves installing the flares according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate …

Care & Cleaning - Bushwacker fender flares are built to last; any detergent you use to wash your vehicle is sufficient to clean the flare. Do not use any harsh abrasive detergents

Pocket Hardware Installation Procedures: Put a Washer (WA1-0012) on each Bolt (SW1-0067).

FRONT MAIN & REAR FLARE ONLY: Place a Nut (NU1-0019) over the end of each Bolt and tighten, using a 1/2” wrench for the Nut and the supplied Torx Bit (SW1-0052) for the Bolt. …

Front Flare Installation Procedures (Passenger’s Side): Remove fi ve factory screws with a 7/32” socket wrench. Remove two rear most factory screws with 9/32” socket wrench. Save screws …

Remove the fl are. Using the marks made in step 18 as a guide, measure inward from the outside edge of the fender to verify proper depth of original marked location. Mark must be minimum of …

A required part of this site couldn’t load. This may be due to a browser extension, network issues, or browser settings. Please check your connection, disable any ...